When PID is disconnected, place the blank J3 connector. Wire connections from PID to Elind rear side Use only one type of input.Ĭonnector for a programmable logical input of the PID controller. As of 2016, switch 6 can switch on the full level of manual operation switch 7 is idle. Rocker switches to switch on/off some of the programmable functions of the Eurotherm PID controller. Switch to select the manual or remote control of the Sorensen voltage or current output. When the switch 3 is in the current position, the potentiometer set the voltage output limit (1 turn = 7.5V). When the switch 3 is in voltage position, the potentiometer sets the current output limit (1 turn = 3.6 A). Rotary switch to select the remote control of Elind voltage or current output.Ī 10-turn potentiometer to set Elind output limit. Rocker switch to select the remote control of Elind or Sorensen power supply. Lower readout (output level in Manual mode temperature setpoint in Auto mode). Upper readout showing measured temperature (Sbr = Sensor break). Block diagram of PID controlled heating system at Endstation A of the BACH beamline.Įurotherm 2408 PID controller with one analog output 0-10 Vdc. Heater current may be displayed and open or short circuit faults detected.The temperature controller box is designed to remotely control Elind () or Sorensen (Model DCS-100-12E) power supplies at BACH beamline, which are used for heaters in the experimental chambers of the Endstation A.Ĭonnections between the controller and other appliances are schematically depicted in Scheme 1. Remove the need for ammeters by using the advanced load current monitoring facility. Simple heat treatment profiles can be programmed using the internal ramp generator and dwell timer. Easy connection through digital commsĭigital communications with industry standard protocols – including Modbus and DeviceNetTM communications – are available for easy connection to supervisory control and data logging systems. The 1/8 and 1/4 DIN units have two digital inputs to select auto/manual transfer, standby mode, second setpoint or alarm acknowledge.

Modular heating and cooling outputs are provided with a choice of one or two alarm relay outputs. All instruments are fully configurable on-site. The hardware is configurable for heating, cooling or alarms. Versatile, high stability temperature or process controllers.Looking for product documents or software? Go to our Download Center.EcoStruxure™ Manufacturing Compliance Advisor.

Eurotherm itools break